Инструкция на миниатюрные софтстартеры Solcon Solstart Софт-стартеры и устройства торможения постоянным током SOLCON стр.2 Table of Contents Page Subject Starter Selection Installation Notes Wiring

Софт-стартеры и устройства торможения постоянным током SOLCON

Инструкция на миниатюрные софтстартеры Solcon Solstart

Table of Contents Page Subject Starter Selection Installation Notes Wiring

Инструкция на миниатюрные софтстартеры Solcon Solstart Table of Contents
Page Subject
Starter Selection
Installation Notes
Wiring
Starter Settings & Start-up Procedure
Dimensions
Technical Specification
Safety
• Read this manual carefully before operating the equipment and follow its instructions.
• Installation, operation and maintenance should be in strict accordance with this
manual, national codes and good practice. Installation or operation not performed in
strict accordance with these instructions will void manufacturer s warranty.
• Disconnect all power inputs before servicing the soft-starter and/or the motor.
• Prior to the installation , check and verify that no parts (bolts, washers, etc) will fall
into the starter.
Attention
This product was designed and tested for compliance with IEC -4-2 for class A equipment.
Use of the product in domestic environments may cause radio interference, in which case the user may
be required to employ additional mitigation methods.
Utilization category is AC-53a or AC53b. Form1.
For further information see Technical Specification.
Warnings
• Internal components and P.C.B s are at Mains potential when the Solstart is connected
to mains. This voltage is extremely dangerous and may cause death or severe injury if
contacted.
• When the Solstart is connected to Mains, even if start signal has not been issued, full
voltage may appear on motor s terminals. Therefore, for isolation purposes it is
required to connect an isolating device (C/B, switch, line contactor, etc) upstream to
the Solstart.
• Starter must be properly grounded (except 8-22A) to ensure correct operation and
safety.
• Check that Power Factor capacitors are not connected to the output side of the soft
starter
The company reserves the right to make any improvements or modifications to its products without prior notice.